RHINO RC456 Betreibershandbuch PDF herunterladen (Seite 12)

CAUTION! Make sure the area around the machine is clear before lowering. Do not lower rakes when people

or pets are near the rakes or folding mechanism.

4. Set the rake angle by repositioning the 5/8" bolt in the rake mounting bracket. Six holes are available for adjust-

ments (See Illustration 4).

See the rake operator's manual for more information on setting the rakes.

5. Working speed is normally 5 to 10 mph. Speed varies with different hay conditions or terrain. Consult the rake

operator's manual for complete operation instructions.

6. To raise the rakes, apply hydraulic pressure to extend the hydraulic cylinder. When the wings are in the retracted

position, install the transport pins in the frame to lock the wings in place.

Note: The wings must be adjusted so that both wings retract into the transport position at approximately the same

time. With the rakes removed from the wings, disconnect the adjustable link between the sliding cylinder mount and

the left wing. Clear the area around the machine and extend the cylinder until the right wing just retracts into the lock

position. Manually retract the left arm to the same position and adjust the link until the pin drops into the pivot point.

Turning the threaded rod end "in" will cause the wing to move towards the tongue. Secure the pin when the adjustment

is complete (See Illustration 5).

CAUTION! The linkage can be adjusted with the rakes installed ONLY if the left wing is locked in the transport

position. If the wing is allowed to extend to the point where the caster wheel is on the axle ramp, the

rake can fall rapidly and possibly cause an injury.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Keine Kommentare

RHINO RC456 Betreibershandbuch Seite 12