RHINO GTR Bedienerhandbuch PDF herunterladen (Seite 2)

PROGRAMMABLE FEATURES:

The features outlined below are the most popular that can be turned on or off to suit your requirements.

Please refer to the section is this manual marked “Rhino Programmable Features” for full details.

PASSIVE ARMING: The alarm can automatically arm itself 30 seconds after you leave your vehicle

provided that the ignition is turned off, and that at least one door has been opened and closed ie. the owner

has parked and has exited the vehicle. This feature will not lock the vehicle where central locking is

connected.

AUTOMATIC RE-ARM : This feature prevents accidental disarming by the owner ie. the owner turns the

alarm off but is then distracted and forgets that they have deactivated the system. If a door is not opened,

or the ignition is not turned on within 60 seconds from when the system is turned off by the remote, the

system will re-arm, and if central locking is connected, it will re-lock the vehicle.

SILENT ARM/DISARM : This feature when turned on, stops the siren from beeping for arm & disarm

confirmation i.e. only the blinkers will flash.

LEARNING NEW REMOTES

(Up to 3 remotes can be used with this alarm system)

Before entering this mode,make sure you have all remotes present that you wish yo utilise with this alarm

system, as the alarm automatically erases all remotes when you enter this mode.

A. Arm then Disarm the alarm system. While the system is disarmed, open and close your drivers door (get

inside the vehicle), making sure the interior light is coming on as you open the door.

B. Within 30 seconds, turn the car ignition key from the off position to the ignition on position 8 times.

C. 10 seconds later, the blinkers will flash 8 times to confirm that you have entered the remote learning

mode. Repeat steps A & B if you do not receive the flashes.

D. Now press & hold Button 1 on the new remote you wish to learn in. The siren will beep once to confirm

the code has been learnt. Repeat this step for up to 3 remotes. You can use this process to delete lost

remote controls by learning in the same remotes in succession to replace each of the 3 memory

locations so that the old remote code/s are erased.

E. The system will automatically exit the learning mode 20 seconds after the last press of a remote.

1 2 3 4 5 6 7 ... 12 13

Keine Kommentare

RHINO GTR Bedienerhandbuch Seite 2