7
GREY
-
Ignition Input. Connect to a +12 volts ignition switched lead, which
does not fall
to 0 volt when the engine is cranked
ORANGE
-
Connect to existing door switches. Please note: only negative switching doors, if
positive door switching - must use relays to reverse to negative - see diagram
contained later in this manual)
ROUND YELLOW TRIM POT ON FAR RIGHT OF MODULE
YELLOW
“TRIM POT”
Sensitivity Adjustment for Car Body Impact Sensor – using a small philips head
screwdriver, turn gently clockwise to increase sensitivity, or anti-clockwise to
decrease sensitivity. Do not force past stops, otherwise you will break . (This is not
covered by warranty). Adjust trim pot & then arm alarm to test. Make small
adjustments until sensitivity is set to an appropriate level.
CURRENT (VOLTAGE DROP) SENSING
The alarm is fitted standard with current sensing. This feature incorporated in Rhino systems has been
proven to be very reliable. The alarm will detect any sudden drop in voltage in the vehicle’s electrical system,
for example if the interior light comes on, or if the electrical system shows a voltage drop through
tampering. PLEASE NOTE: If removal of this feature is necessary i.e. if engine cooling fans run after the
ignition key is turned off, please refer to the Programmable Features section of this manual. You are able to
disable the current sensing feature so that a false alarm condition can not occur.
LOCATION GUIDE FOR SYSTEM COMPONENTS
THE SIREN: Mount the siren to the vehicle’s firewall, close to the bonnet.
DO NOT
mount near the exhaust
manifold or low down in the engine bay where it may be exposed to excessive moisture / road grime etc.
THE CONTROL (MAIN) UNIT: Mount under the dash between the steering column & the centre of the
ehicle. Cable tie the unit to a large cable (20mm diameter or larger) or to a heavy strut.
SECURITY OVERRIDE MODE:
If a customer loses a remote control, or it fails to disarm the alarm system, the following procedure will
disarm the alarm system.
1. Open & close the drivers door - sit in the vehicle. (The siren will sound).
2. Within 20 seconds, turn the ignition from off to on 10 times. Wait for 5 seconds.
3. The system will then disarm.
4. Contact your Rhino Dealer for further assistance.
IMPORTANT NOTE FOR INSTALLERS
:
Vehicles fitted with negative
or positive switching doors.
In order for the alarm system to function correctly, it is necessary for the doors to be
hard wired to the system . Please follow the wiring diagram s below:
NEGATIVE SW ITCHING DOO RS:
PO SITIVE SW ITCHING DOO RS: Use relay.
+12V
Interior light
orange wire ALARM 86
30 87a 87 Orange wire ALARM
Door Switch
85
Door Switch
+12V
(9 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern