6
WIRING INSTRUCTIONS FOR RHINO GTR ALARM
2 X SPADE CONNECTORS, LEFT HAND SIDE OF MODULE
LIGHT BLUE x 2
with Spade
Terminals. (1
Pair)
-
Immobilisation Circuit. (Starter Motor or Fuel Pump). The starter wire is usually
located under the steering column of the vehicle. This wire must be +12 Volts
only when the vehicle is being started. Cut this wire. The vehicle should not start.
Solder the starter motor side to one of the blue wires. Solder the other end to
the other blue wire. Under no circumstances should you cut the vehicle’s main
ignition system. Wire you cut should not carry current greater than 15 Amps.
LARGE CONNECTOR BLOCK – WIRES LEFT TO RIGHT
BLACK
-
Earth. Connect to a suitable earth on the car body.
BLUE/YELLOW
-
Lock NO. Refer to diagrams contained later in this manual for central locking
connection .
RED/GREEN
-
Lock COM. Refer to diagrams contained later in this manual for central locking
connection .
BLACK/GREEN
-
Lock NC. Refer to diagrams contained later in this manual for central locking
connection .
RED/BLUE
-
Unlock NO. Refer to diagrams contained later in this manual for central locking
connection .
GREEN/YELLOW
-
Unlock COM. Refer to diagrams contained later in this manual for central locking
connection .
BLACK/BLUE
-
Unlock NC. Refer to diagrams contained later in this manual for central locking
connection .
GREEN
-
Indicator Flash Wire. Connect to the left hand indicator circuit of the vehicle.
RED with
15A Fuse
-
Power. Connect to constant +12 volts via the fuse box at the point where the
interior light circuit is powered. Current (voltage) sensing will not work if this
procedure is not followed. Make sure the fuse is firmly pushed into its holder.
GREEN
-
Indicator Flash Wire. Connect to the right hand indicator circuit of the vehicle.
SMALL CONNECTOR BLOCK – WIRES LEFT TO RIGHT
RED
Positive LED Output
- already connected to the LED supplied.
BROWN
-
Negative Boot Release Output (200mA Max). Please refer to the illustrated
diagram for connection details. Additional 40A Changeover Relay Required.
WHITE
-
Negative Trigger Input. Connect to negative trigger output wire from optional
ultrasonics or microwave sensor.
YELLOW
-
Positive Siren Trigger (1Amp max rating). This wires switches positive when the
alarm is triggered. It also pulses positive to make the siren beep. Connect to the
yellow positive trigger input wire on the SBB Multi-Tone Backup Battery Siren.
BLUE
-
Negative LED Output - already connected to the LED supplied.
PINK
-
Negative on Arm (500mA Max). Connect to the negative wire (usually black) on
any accessory used ie. ultrasonic or microwave detectors. Also used to trigger
electric window lift modules.
Fuel
Pump or
Starter
Motor
Main Module
Blue
Blue
(9 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern